Just a note. I changed motors from the one pictured at the top of the page.
| J A Fay & Egan Lightning 500 Varity Saw 2 | |||
|
Rear view, with the new motor sitting on blocks where it will mount. | ||
| Another view of the rear of the saw. Note how much smaller the new motor is in relation to the original. |
|
||
|
|
There is the table being cleaned in a "Porta-Tankee" | ||
| Here are some of the parts that had to be replaced. Note the piece to the right of the two miter gears. It is part of the shaft that held the motor mounting plate to the base. It is 1 1/4" in diameter. The shiny spot near the center is all that was left, the rest had rusted away. |
|
||
|
|
Here is the saw almost completed. All that is lacking is clamping down the BX conduit to the switch and installing the belt guard. | ||
| Finally, It is all completed. Now to
clean up the shop, build a rip fence and miter gauge. Just a note. I changed motors from the one pictured at the top of the page. |
|
||